Fuji Xerox ApeosPort-IV C7780

Connectivity & Network Setup
195
Tools
5
Note • Select a communication mode to send data scanned via FTP from [Passive mode] and
[Active mode]. [Passive mode] is selected by factory default. You can change the setting
from CentreWare Internet Services.
Receive E-mail
Port Status
Select [Enabled] when you receive e-mails and Internet faxes.
Send E-mail
Port Status
Select [Enabled] when you send e-mails and Internet faxes.
E-mail Notification Service
Port Status
Select [Enabled] when you use the E-mail Notification Service. The E-mail Notification
Service notifies you of the machine status or the completion of a print job, and a direct fax job
by e-mail.
Note • [Consumables Status], [Parts Status], [Paper Tray Status], [Output Tray Status],
[Jam Status], [Interlock Status], and [Fault Notice] are notified as the machine
status.
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
UPnP Discovery
Port Status
Select [Enabled] to use UPnP.
Port Number
Enter a port number for UPnP communication from 1 to 65535.
The default value is 80.
Important • Using the default port number may cause the conflict with other ports. Confirm the setting
that the port numbers assigned to the other ports are not used.
WSD
WSD Print - Port Status
Select [Enabled] to use WSD Print.
Set this when you search a device on a network from Windows
®
Vista
®
and Windows 7.
Port Number
Enter a port number from 1 to 65535.
The default value is 80.
Important • Using the default port number may cause the conflict with other ports. Confirm the setting
that the port numbers assigned to the other ports are not used.
Note • WSD stands for Web Services on Devices.
Internet Services (HTTP)
Port Status
Select [Enabled] to use CentreWare Internet Services.
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services
Settings" (P.293).
Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.