EasyManuals Logo

Fuji Xerox ApeosPort-IV C7780 Administrator's Guide

Fuji Xerox ApeosPort-IV C7780
739 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #342 background imageLoading...
Page #342 background image
9 Scanner Environment Settings
342
Scanner Environment Settings
9
Configuration of Job Flow Sheets
This section describes how to configure the machine to use the Job Flow Sheets
service.
The following shows the reference section for each procedure.
Step 1 Enabling Ports and Setting up TCP/IP...........................................................................342
Step 2 Configuring the SNMP Port...........................................................................................343
Step 3 Configuration on the Computer .....................................................................................343
Step 1 Enabling Ports and Setting up TCP/IP
To use the Job Flow Sheets service, enable the SOAP, SNMP, and Internet Services
(HTTP) ports, and set an IP address and other addresses. The following describes the
configuration procedures on the machine.
Note • You can configure the settings using CentreWare Internet Services. For information on how
to use CentreWare Internet Services, refer to "CentreWare Internet Services Settings"
(P.293).
1 Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator’s user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator’s
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
2 Enable the SOAP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SOAP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Port Settings] screen is displayed.
3 Enable the SNMP port.
1) Select [SNMP], and then select [Change Settings].
2) Select [Port Status], and select [Change Settings].
3) Select [Enabled], and then select [Save].
4) Select [Close] repeatedly until the [Port Settings] screen is displayed.
5) Enable the Internet Services (HTTP) port as described above.
6) Select [Close] repeatedly until the [Tools] screen is displayed.
4 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for
obtaining the addresses. If an IP address cannot be obtained automatically or manual

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C7780

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C7780 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C7780 Specifications

General IconGeneral
BrandFuji Xerox
ModelApeosPort-IV C7780
CategoryAll in One Printer
LanguageEnglish

Related product manuals