16 Appendix
662
Appendix
16
PCL Settings List
The following table describes the parameters that can be set with the mode menu.
Parameter
I
tem No. Value
Paper tray 201 Sets the paper tray to be used for printing.
[0] (Default) : Auto
[1] : Tray 1
[2] : Tray 2
[3] : Tray 3
[4] : Tray 4
[5] : Tray 5
[6] : Tray 6 (HCF B1-S) or (HCF2 (2000 sheets)
Important • When Trays 1 to 4, or Tray 6 is selected, the paper size is
determined by the size of paper loaded in the tray, and thus [Paper
Size] cannot be set.
Note • When [Auto] is selected and paper of the same size in the same
orientation in multiple trays is loaded, paper will be fed in the order of
Tray 1 J Tray 2 J Tray 3J Tray 4 J Tray 6. If paper of the same
size is loaded in multiple trays but in different orientations, feeding of
the paper loaded in the landscape orientation is prioritized.
Auto size 202 Sets the default paper size. Only available when [Paper Tray] is set to
[Auto]. Only cut sheet can be set.
[3] : A3
[4] (Default*) : A4
[5] : A5
[14] : B4
[15] : B5
[21] : 8.5 × 14”
[22] : 8.5 × 13”
[23] (Default*) : 8.5 × 11”
[24] : 11 × 17”
[25] : Custom Size
[30] : 8K
Important • When Trays 1 to 4, or Tray 6 is selected, [Paper Size] cannot be set.
The paper size loaded in the specified tray is displayed.
Note • When Trays 1 to 4, or Tray 6 is selected, the paper size is
determined by the size of paper loaded in the tray, and thus [Paper
Size] cannot be set.
• Depending on the combination of [Original Size] and [Paper Size], [?]
may be displayed for the magnification. In this case, the document is
printed at a scale of 100%.
Bypass size 203 Sets the default paper size. Only available when [Paper Tray] is set to
[Auto]. Only cut sheet can be set.
[3] : A3
[4] (Default*) : A4
[5] : A5
[14] : B4
[15] : B5
[21] : 8.5 × 14”
[22] : 8.5 × 13”
[23] (Default*) : 8.5 × 11”
[24] : 11 × 17”
[25] : Custom Size
Output
destination
204 Sets the output tray for the printouts.
[0] (Default) : Right Top Tray
[81] : Right Middle Tray
To Next Page
Loading...
Need help?
General
