Changing the Paper Size
61
Paper and Other Media
2
4 Load and align the edge of the paper against
the left edge of the tray with the side to be
copied or printed on facing down.
Important • Do not load paper exceeding the
maximum fill line. It might cause paper
jams or machine malfunctions.
5 Push the tray in gently until it comes to a stop.
Important • When pushing the paper tray in, do it slowly. If the tray is pushed with too much force, it
might cause machine malfunctions.
6 Specify the type of the paper loaded when you have changed the paper type.
For information on how to set the paper types, refer to "Changing the Paper Settings" (P.65).
Changing the Paper Size for Tray 6 (HCF2 (2000 sheets))
The following describes how to change the paper size for Tray 6 (HCF2 (2000 sheets)).
1 Pull out Tray 6 towards you until it stops.
Important • While the machine is processing a job, do not pull the tray out that the job uses.
• Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or any other troubles. First, remove the remaining paper in the tray, and then load the
new stack of paper.
2 Remove any paper loaded in the tray.
3 Open the end guide (1) and unscrew the
screw (2). Then remove the guide from the
tray.
CAUTION
Make sure to pull out the tray
slowly. When the tray is being
pulled out with force, the tray
may possibly hit your knees or
other parts of your body causing
injuries.
To Next Page
Loading...
Need help?
General
