EasyManuals Logo

Fuji Xerox ApeosPort-IV C7780 Administrator's Guide

Fuji Xerox ApeosPort-IV C7780
739 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #306 background imageLoading...
Page #306 background image
7 Printer Environment Settings
306
Printer Environment Settings
7
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3 Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for
obtaining the address. The configuration of an IP address, a subnet mask, and a
gateway address is not required.
For information on how to set an IP address, refer to "Protocol Settings" (P.196).
4 If the operating system on the client is Mac OS X 10.3.9 or later, enable the Bonjour
port, and the Discovery feature that automatically detects printers on the IP network
can be enabled.
Note • The Adobe PostScript 3 Kit (optional) is required to use the port. However, for Mac OS X
10.4.11 or later, you can use the port without the Adobe PostScript 3 Kit (optional).
• To print from a printer detected by Bonjour, the LPD
port must be enabled in advance.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Bonjour], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
5 Select [Close] repeatedly until the [Tools] screen is displayed.
6 Select [Close].
Note • Rebooting the machine may be required depending on the settings. When a message
displayed on the screen, follow the message and reboot the machine.
7 Print a configuration report to confirm that the LPD port is enabled and that TCP/IP is
set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.111).
8 Configure other LPD or Port 9100 settings as necessary.
For information on how to set up the LPD port or Port 9100, refer to "CentreWare Internet Services
Setting Items" (P.307).
Step 3 Configuration on the Computer
To print from the machine, you need to install a print driver on your computer.
For information on the supported operating systems, refer to "Supported Operating Systems" (P.302).
For information on the driver installation procedures, refer to the manual contained in the Driver CD
Kit.
You can print via TCP/IP (LPD) from a Macintosh computer for Mac OS X 10.5/10.6. For information
on the installation procedures of the print driver for Mac OS X, refer to the manual contained in the CD-
ROM provided with the driver.
For information on the installation procedures of Adobe PostScript 3 Kit (optional), refer to the manual
contained in the CD-ROM provided with the Adobe PostScript 3 Kit (optional).

Table of Contents

Other manuals for Fuji Xerox ApeosPort-IV C7780

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fuji Xerox ApeosPort-IV C7780 and is the answer not in the manual?

Fuji Xerox ApeosPort-IV C7780 Specifications

General IconGeneral
BrandFuji Xerox
ModelApeosPort-IV C7780
CategoryAll in One Printer
LanguageEnglish

Related product manuals