Copy Service Settings
189
Tools
5
Fine-tune 100%
You can fine-tune magnification when copying at 100% (actual size). The set value is applied
to [100%] in the [Copy] screen is set to 100%.
Set the value in the X/Y direction between 98 and 102% in 0.1% increments.
Important • This feature is applied only when a copy is made using the document glass. This setting is
not reflected in the magnification (100%) under [Independent X-Y%] or [Calculator %].
Note • A magnification displays [100%] even if [Fine-tune 100%] is selected.
ID Card Copy - Reduce/Enlarge
Set the copy magnification ratio when to copy ID cards. Selecting [Allow to Change] allows
you to specify the ratio between 25 to 400 % in 1 % increments.
Note • The machine may copy an ID card in a different orientation from the original orientation
depending on the magnification ratio you specified.
Background Suppression (Photo & Text)
Set the background suppression level for color copying. This setting is valid when [Photo &
Text] is selected for [Original Type] in the [Image Quality] screen.
The larger the value, the stronger the effect of removing background noise.
Background Suppression Level (Text)
Set the background suppression level for color copying. This setting is valid when [Text] is
selected for [Original Type] in the [Image Quality] screen.
The larger the value, the stronger the effect of removing background noise.
Photo & Text /Printed Original
Set the type of document when [Printed Original] of [Photo & Text] is selected for [Original
Type] in the [Image Quality] screen.
îš„Normal
Copies with standard image quality.
îš„Inkjet Originals
Select [Inkjet Originals] when copying a document printed with an inkjet printer. This
improves the recognition of inkjet colors.
îš„Highlighted Originals
Select [Highlighted Originals] when copying an original marked with a highlight pen. This
improves the recognition of the colors of highlight pen.
Original Type - See-Through Paper
When [Text] is selected for [Original Type] in the [Image Quality] screen, set whether or not to
display [Text on See-Through Paper].
Face Up/Down - Reverse Order
Set whether or not to display [Face Up (Reverse Order] under [Face Up/Down Output] in the
[Output Format] screen.
Face Up/Down - Auto (Single Sheet)
Specify the operation of the machine when [Face Up/Down Output] is set to [Auto] in the
[Output Format] screen, and a single sheet is output.
Annotations - Comment Density
Set the translucency of the comment printed as annotation.
You can select a translucency value from [Darken], [Normal], and [Lighten]. Darken
represents no translucency.
To Next Page
Loading...
Need help?
General
