Error Code
549
Problem Solving
15
133-710
[Cause] When printing the received fax document, the paper loaded in the bypass
tray was used for printing because the specified tray could not be used.
[Remedy] Take one of the following measures:
z
Load paper available for printing the received fax document:
A3 SEF , A4 LEF , B4 SEF , B5 LEF ,
A4 SEF , A5 SEF , B5 SEF , 8.5 x 11" SEF ,
8.5 x 13" SEF , 8.5 x 14" SEF , 11 x 17" SEF ,
8.5 x 11" LEF
, 5.5 x 8.5" SEF .
z
Use a paper type available for printing the received fax document:
plain paper, bond paper, recycled paper, side 2 paper, user-defined
custom paper.
z
Confirm the settings by selecting [Tools] > [Fax Service Settings] > [Fax
Control] > [Receiving Paper Size].
1. Select [Receiving Paper Size] > [Tray Mode] to add a tray to be used for
printing the received fax documents.
2. Set up paper so that the tray specified tray in [Tray Mode] can be used
for printing the received fax documents.
If the error still is not resolved, contact our Customer Support Center.
Error Code Cause and Remedy
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
