30. Alerts
30-11
Alert number 480: TRACKPILOT RECEIVE ERROR /5/12
------------------------------------
ECDIS CANNOT RECEIVE ANY DATA FROM
TRACKPILOT. CHANGE "MAIN STEERING"
-SELECT OR TO ANY OTHER POSITION THAN
AUTOP. CHECK AND VERIFY TRACKPILOT
OPERATION BEFORE NEW TRY
Alert number 488: TRACK CONTROL STOPPED /3
------------------------------------
CONNECTION TO THE TRACKPILOT HAS
BEEN LOST WHILE THE SYSTEM PERFORMED
ONE OF THE INTEGRATED STEERING MODES:
- GOTO TRACK
- GOTO WPT
- PROGRAM TRACK
CURRENT STEERING MODE CANNOT CONTINUE
CHECK NEW STEERING SITUATION
Alert number 600: PARAM CHANGE DISABLED /3
------------------------------------
INSTALLATION PARAMETERS CANNOT BE
CHANGED IF THE ROUTE STEERING IS ON
OR THE KALMAN FILTER IS IN USE.
CHECK THE SITUATION AND TRY AGAIN.
Alert number 601: PARAM CHANNEL CONFLICT /4
-------------------------------------
IF IN INSTALLATION PARAMETERS THERE
ARE MORE THAN ONE DEVICE USING SAME
CHANNEL AND IF IN THAT CASE NO OTHER
DEVICES ARE ALLOWED FOR PARALLEL USE,
THEN ALERT 3001 APPEARS.
NOTE: IN SOME SPECIAL CASE MORE THAN
ONE DEVICES CAN IN PARALLEL USE SAME
CHANNEL (FOR EXAMPLE LOG + DAX)
Alert number 610: FILTER: INIT ERROR /4
-------------------------------------
INITILATION OF FILTER FAILED. CHECK
SELECTED POSITIONING SENSORS. TRY
SWITCH FILTER ON.
Alert number 632: AIS DANGEROUS TARGET /2/9
------------------------------------
AIS TARGET HAS MET DANGEROUS TARGET
LIMIT SET BY CPA AND TCA
Alert number 633: LOST AIS TARGET /5
------------------------------------
NO Update INFORMATION RECEIVED FROM
TRACKED AIS TARGET WITHIN DEFINED
REPORTING INTERVAL OF SHIP TYPE
Alert number 634: AIS MESSAGE RECEIVED /3 or /10
------------------------------------
AIS MESSAGE RECEIVED.
To Next Page
