GE D90 Plus - Flexstate Actual Values

CHAPTER 6: COMMUNICATIONS FLEXSTATES
D90
PLUS
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL 145
Figure 118: FlexStates configuration settings
The following settings are available.
Parameter 1 through Parameter 256
Range: any FlexLogic operand
Default: Off
These settings assign FlexLogic parameters to each of the 256 FlexStates. The FlexState
register array begins at Modbus address 0900h.
FlexState actual values
Select the Actual Values > Communications > FlexStates menu to open the FlexStates
actual values window.
Figure 119: FlexStates actual values
The following actual values are available for each FlexState parameter.