GE D90 Plus - Automation Flexanalog Parameters

CHAPTER 8: AUTOMATION AUTOMATION FLEXANALOG PARAMETERS
D90
PLUS
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL 491
Automation FlexAnalog parameters
The following automation FlexAnalog parameters (analog operands) are available for the
D90
Plus
. They are listed alphabetically by operand syntax.
Synchrocheck analog operands
Synchchk 1 Delta V ................................... Metered voltage difference for the synchrocheck 1 element
Synchchk 1 Delta F.................................... Metered frequency difference for the synchrocheck 1 element
Synchchk 1 Delta Phs .............................. Metered phase difference for the synchrocheck 1 element
Synchchk 2 Delta V ................................... Metered voltage difference for the synchrocheck 2 element
Synchchk 2 Delta F.................................... Metered frequency difference for the synchrocheck 2 element
Synchchk 2 Delta Phs .............................. Metered phase difference for the synchrocheck 2 element