GE D90 Plus - Shared Digital Fault Recorder Operands

530 D90
PLUS
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
USING SHARED OPERANDS IN DIGITAL FAULT RECORDER CHAPTER 10: DIGITAL FAULT RECORDER
Figure 462: Default operand list by function
The content of each operand list depends on the order code.
The shared operands functionality expands upon this system. An output from any element
can be assigned as a shared operand within the EnerVista UR
Plus
Setup software. These
signals then can be assigned as inputs to other functions.
For example, assume that the GND TOC1 OP protection operand is required as a signal
within the automation function. This operand then is assigned as a shared operand and
subsequently becomes available to the automation function. A total of 64 operands can be
assigned as shared operands within each function.
Shared digital fault recorder operands
Select the Settings > DFR > Shared Operands menu to select the shared digital fault
recorder operands.
$&'5
(OHPHQWV
)OH[/RJLF
&RQWDFWRXWSXWV
5HPRWHRXWSXWV
3URWHFWLRQ
3URWHFWLRQRSHUDQGV
9LUWXDORXWSXWV
9LUWXDOLQSXWV
5HPRWHLQSXWV
(OHPHQWV
)OH[/RJLF
&RQWDFWRXWSXWV
$XWRPDWLRQ
%DWWHU\PRQLWRU
(TXLSPHQWPDQDJHU
'DWDORJJHU
6\QFKURSKDVRUV
0HWHULQJ
0HWHULQJRSHUDQGV
7UDQVLHQWUHFRUGHU
'LVWXUEDQFHUHFRUGHU
)DXOWUHSRUW
'LJLWDOIDXOWUHFRUGHU
$QQXQFLDWRU
)URQWSDQHO+0,
$XWRPDWLRQRSHUDQGV
$XWRPDWLRQFRQWDFWLQSXWV
9LUWXDORXWSXWV
9LUWXDOLQSXWV
3URWHFWLRQFRQWDFWLQSXWV
$XWRPDWLRQFRQWDFWLQSXWV
0HWHULQJRSHUDQGV
9LUWXDORXWSXWV
3URWHFWLRQRSHUDQGV
9LUWXDORXWSXWV
3URWHFWLRQRSHUDQGV
$XWRPDWLRQRSHUDQGV
9LUWXDORXWSXWV
$XWRPDWLRQYLUWXDORXWSXWV
(TXLSPHQWPDQDJHURSHUDQGV
0HWHULQJRSHUDQGV
'LJLWDOIDXOWUHFRUGHURSHUDQGV
3URWHFWLRQRSHUDQGV
9LUWXDORXWSXWV)OH[/RJLF
$XWRPDWLRQRSHUDQGV
9LUWXDORXWSXWV)OH[/RJLF
(TXLSPHQWPDQDJHURSHUDQGV