GE D90 Plus - Metering Flexanalog Parameters

CHAPTER 11: METERING METERING FLEXANALOG PARAMETERS
D90
PLUS
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL 577
PMU 1 POWER TRIGGER.......................... Asserted when the overpower trigger of Phasor Measurement
Unit 1 operates.
PMU 1 ROCOF TRIGGER........................... Asserted when the rate of change of frequency trigger of
Phasor Measurement Unit 1 operates.
PMU 1 TRIGGERED..................................... Asserted when the Phasor Measurement Unit 1 triggers. No
events or targets are generated by this operand.
PMU 1 VOLT TRIGGER ............................... Asserted when the abnormal voltage trigger of Phasor
Measurement Unit 1 operates.
Phasor Measurement Unit one-shot operands
PMU ONE-SHOT EXPIRED ....................... Asserted after the one-shot operation executes.
PMU ONE-SHOT OP ................................... Asserted upon one-shot operation.
PMU ONE-SHOT PENDING...................... Asserted while the one-shot operation is pending. That is, while
the present time is before the scheduled one-shot time.
Metering FlexAnalog parameters
The following metering FlexAnalog parameters (analog operands) are available for the
D90
Plus
. They are listed alphabetically by operand syntax.
Phasor Measurement Unit analog operands
PMU 1 Conf Ch ............................................ Metered configuration change counter value for Phasor
Measurement Unit 1
PMU 1 df dt ................................................... Metered frequency rate of change value for Phasor
Measurement Unit 1
PMU 1 Freq.................................................... Metered frequency value for Phasor Measurement Unit 1
PMU 1 Num Triggers ................................ Metered number of triggers for Phasor Measurement Unit 1
PMU 1 Ia Mag............................................... Metered phase A current magnitude for Phasor Measurement
Unit 1
PMU 1 Ia Ang................................................ Metered phase A current angle for Phasor Measurement Unit 1
PMU 1 Ib Mag............................................... Metered phase B current magnitude for Phasor Measurement
Unit 1
PMU 1 Ib Ang................................................ Metered phase B current angle for Phasor Measurement Unit 1
PMU 1 Ic Mag............................................... Metered phase C current magnitude for Phasor Measurement
Unit 1
PMU 1 Ic Ang................................................ Metered phase C current angle for Phasor Measurement Unit 1
PMU 1 Ig Mag............................................... Metered ground current magnitude for Phasor Measurement
Unit 1
PMU 1 Ig Ang................................................ Metered ground current angle for Phasor Measurement Unit 1
PMU 1 I0 Mag............................................... Metered zero-sequence current magnitude for Phasor
Measurement Unit 1
PMU 1 I0 Ang................................................ Metered zero-sequence current angle for Phasor Measurement
Unit 1
PMU 1 I1 Mag............................................... Metered positive-sequence current magnitude for Phasor
Measurement Unit 1
PMU 1 I1 Ang................................................ Metered positive-sequence current angle for Phasor
Measurement Unit 1
PMU 1 I2 Mag............................................... Metered negative-sequence current magnitude for Phasor
Measurement Unit 1
PMU 1 I2 Ang................................................ Metered negative-sequence current angle for Phasor
Measurement Unit 1