592 D90
PLUS
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL
MIMIC DIAGRAM EDITOR CHAPTER 12: LOCAL INTERFACE
Figure 520: Mimic diagram metering block symbol
The properties of a metering block can be configured by right-clicking the box and
selecting Properties to open the Metering Properties configuration window.
Figure 521: Metering properties configuration window
The following parameters are available.
Parameter
Range: any analog actual value
Default: Analog 1 (VA1)
This setting selects the actual value to be displayed in the metering block.
Label
Range: up to 40 ASCII characters
Default: Analog 1 (VA1)
This setting allows the user to specify a custom label for the metering block if the actual
value name is insufficient.
Units
Range: up to 4 ASCII characters
Default: ---
This setting allows the user to specify a custom units value for the metering block if the
actual value unit designation is insufficient.
,QWHUIDFH V\PEROV7H[W EORFN W\SH
%XWWRQ ([DPSOH GLVSOD\
0HWHUHG WH[W EORFN
$&'5
To Next Page
Loading...
