CHAPTER 13: SECURITY PASSWORD SECURITY
D90
PLUS
LINE DISTANCE PROTECTION SYSTEM – INSTRUCTION MANUAL 611
Local Command Password
Range: up to 12 visible ASCII characters (see restrictions outlined)
Default: null
The value of the local command password is specified here. For the password to be
successfully entered, the values in the
Enter New Password and Confirm New Password
fields must be identical.
If an entered password is lost (or forgotten), consult the factory with the corresponding
Encrypted Password value.
Local Setting Password
Range: up to 12 visible ASCII characters (see restrictions outlined)
Default: null
The value of the local setting password is specified here. For the password to be
successfully entered, the values in the
Enter New Password and Confirm New Password
fields must be identical.
If an entered password is lost (or forgotten), consult the factory with the corresponding
Encrypted Password value.
Remote Command Password
Range: up to 12 visible ASCII characters (see restrictions outlined)
Default: null
The value of the remote command password is specified here. For the password to be
successfully entered, the values in the
Enter New Password and Confirm New Password
fields must be identical.
If an entered password is lost (or forgotten), consult the factory with the corresponding
Encrypted Password value.
Remote Setting Password
Range: up to 12 visible ASCII characters (see restrictions outlined)
Default: null
The value of the remote setting password is specified here. For the password to be
successfully entered, the values in the
Enter New Password and Confirm New Password
fields must be identical.
If an entered password is lost (or forgotten), consult the factory with the corresponding
Encrypted Password value.
The following access supervision settings allow the user to specify the length of inactivity
required before returning to the restricted access level.
Command Password Access Timeout
Range: 5 to 480 minutes in steps of 1
Default: 5 minutes
This setting specifies the length of inactivity (no local or remote access) required to
return to restricted access from the command password level.
Setting Password Access Timeout
Range: 5 to 480 minutes in steps of 1
Default: 30 minutes
This setting specifies the length of inactivity (no local or remote access) required to
return to restricted access from the setting password level.
To Next Page
Loading...
