GE LOGIQ P6 Series User Manual

GE HEALTHCARE
DIRECTION 5394152, Revision 5
LOGIQ™ P6/P6 PRO SERVICE MANUAL
Page 4-38 Section 4-9 - Board Function Checks
4-9-1 PI128II Assy function check procedure (cont’d)
10.)Activate probe. Refer to the 4-3-7-2 "Activating the probe" on page 4-10.
11.)Check the system basic functions. Refer to the 4-3-4 "System B/M-Mode Checks" on page 4-7 and
refer to the 4-3-5 "System CFM and PWD Checks" on page 4-8.
12.)Disconnect probe. Refer to the 4-3-7-4 "Disconnecting the probe" on page 4-10.
13.)Connect probe on port 2 and repeat step 8) ~ 10).
14.)Connect probe on port 3 and repeat step 8) ~ 10).
15.)All basic functions must show correct operation as described.

GE LOGIQ P6 Series Specifications

General

Power Supply	100-240 VAC, 50/60 Hz
Imaging Modes	B-Mode, M-Mode, Color Doppler, Power Doppler
Applications	Vascular, Musculoskeletal
Operating Temperature	10°C to 40°C
Display	15-inch LCD
Relative Humidity	20% to 80% (non-condensing)