GE LOGIQ P6 Series User Manual

GE HEALTHCARE
DIRECTION 5394152, Revision 5
LOGIQ™ P6/P6 PRO SERVICE MANUAL
Chapter 8 - Page 8-97
8-2-45 AP950 Assy
8-2-45-1 Tools
• Common Phillips screwdrivers
• Allen/Unbraco wrench
8-2-45-2 Preparations
• Shut down the system and switch off the main breaker.
8-2-45-3 Removal procedure
• To detached the AC Power assy, All open 4 pcs console cover that are left, right, front, rear cover.
1.) Remove side left cover and right side cover. Refer to the 8-2-14 "Right or Left Side Cover" on page
8-48 and 8-2-14 "Right or Left Side Cover" on page 8-48.
2.) Remove rear side cover and front cover. Refer to the 8-2-15 "Front Cover" on page 8-50 and 8-2-
16 "Rear Cover" on page 8-52.
3.) Unscrew 2 M4 screws and 2 Hexa screws on the front of AC trans box.
4.) Loosen 2 Hex (left side in Figure 8-144)screws and 4 M4 screws (right side of Figure 8-142).
Figure 8-141 4 screw on the front of the AC TRANSBOX
Figure 8-142 Back of the AC TRANSBOX

GE LOGIQ P6 Series Specifications

General

Power Supply	100-240 VAC, 50/60 Hz
Imaging Modes	B-Mode, M-Mode, Color Doppler, Power Doppler
Applications	Vascular, Musculoskeletal
Operating Temperature	10°C to 40°C
Display	15-inch LCD
Relative Humidity	20% to 80% (non-condensing)