GE LOGIQ P6 Series User Manual

GE HEALTHCARE
DIRECTION 5394152, Revision 5
LOGIQ™ P6/P6 PRO SERVICE MANUAL
Page 10-2 Section 10-2 - Why do Maintenance
Section 10-2
Why do Maintenance
10-2-1
Quality Assurance
In order to gain accreditation from organizations
such as the American College of Radiology (USA), it
is the customer’s responsibility to have a quality assurance program in place for each scanner. The
program must be directed by a medical physicists, the supervising radiologist/physician or
appropriate designee.
Routine quality control testing must occur regularly. The same tests are performed during each
period so that changes can be monitored over time and effective corrective action can be taken.
Testing results, corrective action and the effects of corrective action must be documented and
maintained on the site.
Your GE service representative can help you with establishing, performing and maintaining records
for a quality assurance program. Please contact us for coverage information and/or price for service.
Section 10-3
Maintenance Task Schedule
10-3-1 How often should care & maintenance tasks be performed?
The Care & Maintenance Task Schedule (provided on page 10-3) specifies how often your LOGIQ™
P6/P6 Pro should be serviced and outlines items requiring special attention.
NOTE: It is the customer’s responsibility to ensure the LOGIQ™ P6/P6 Pro care & maintenance is
performed as scheduled in order to retain its high level of safety, dependability and
performance.
Your GE Service Representative has an in-depth knowledge of your LOGIQ™ P6/P6 Pro ultrasound
scanning system and can best provide competent, efficient service. Please contact us for coverage
information and/or price for service.
The service procedures and recommended intervals shown in the Care & Maintenance Task Schedule
assumes that you use your LOGIQ™ P6/P6 Pro for an average patient load (10-12 per day) and not
use it as a primary mobile unit which is transported between diagnostic facilities.
NOTE: If conditions exist which exceed typical usage and patient load, then it is recommended to
increase the maintenance frequencies.

GE LOGIQ P6 Series Specifications

General

Power Supply	100-240 VAC, 50/60 Hz
Imaging Modes	B-Mode, M-Mode, Color Doppler, Power Doppler
Applications	Vascular, Musculoskeletal
Operating Temperature	10°C to 40°C
Display	15-inch LCD
Relative Humidity	20% to 80% (non-condensing)