GE LOGIQ P6 Series

GE HEALTHCARE
DIRECTION 5394152, Revision 5
LOGIQ™ P6/P6 PRO SERVICE MANUAL
Page 8-136 Section 8-4 - Software Installation
8-4-4-9 Regional Setup Procedure for Japanese
You can set up the keyboard for Japanese. If you select Japanese, the following items display or may
be entered in Japanese.
• Patient Name
• Exam Comment (on Patient screen and Worksheet)
• Annotation (Comments)
• Error/Warning Messages
• DICOM/Worklist
1.) In Utility--> System--> General, set the Language as JPN. Save this setting, but do not reboot th
e
sys
tem yet.
2.) Press Regional Options, under Standards and Formats select Japanese, under Location select
Japan. Press Apply.
Figure 8-205 Changing the System Language to JPN
Figure 8-206 Regional Options