GE Revolution CT - Page 17

5.1 Timing Parameters collection............................................................................................. 287
5.2 Timing parameters workflow ..............................................................................................287
5.2.1 Set Prep Delay time ..................................................................................................287
5.2.2 Set Inter Scan Delay time..........................................................................................288
6 Recon Parameters.......................................................................................................................289
6.1 Recon Parameter descriptions........................................................................................... 289
6.1.1 Recon Type............................................................................................................... 289
6.1.2 Hi Res........................................................................................................................289
6.1.3 Axial Plus Recon Mode..............................................................................................289
6.1.4 Cardiac Axial Plus Recon Mode................................................................................ 289
6.1.5 Full and Plus Recon Modes for Helical scan types....................................................289
6.1.6 IQ Enhance for Helical scan types.............................................................................289
6.1.7 Quality Check (QC) Images.......................................................................................290
6.1.8 Flip / Rotate............................................................................................................... 290
6.1.9 Copy Forward............................................................................................................ 291
6.2 Primary Recon collection....................................................................................................291
6.3 Primary Recon parameters workflow..................................................................................293
6.3.1 Set the Slice Thickness............................................................................................. 293
6.3.2 Set the Image Interval................................................................................................293
6.3.3 Set the Recon Type...................................................................................................294
6.3.4 Set Recon Options for Helical scan types................................................................. 295
6.3.4.1 Recon Mode..................................................................................................... 295
6.3.4.2 IQ Enhance.......................................................................................................295
6.3.5 ASiR-V for all scan types...........................................................................................295
6.3.6 Adjust Window Width and Window Level for all scan types...................................... 295
6.3.7 Image Flip Orientation for all scan types................................................................... 296
6.4 Secondary Recon Parameters........................................................................................... 296
6.4.1 Overlapped Axial Recon mode..................................................................................299
6.4.2 Secondary Recon Slice Thickness............................................................................ 299
7 Auto Voice................................................................................................................................... 301
7.1 Auto Voice workflow ......................................................................................................... 301
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Table of Contents 17