Element Description
[Confirm Settings] Ends prescription preview mode.
NOTE:
This is not available if the patient has not been landmarked or if invalid parameters
exist in the
Scan Settings
window.
[Close Exam] Closes the patient exam session.
Table 7: Scan Setup window — Right-click Selections
Element Description
Duplicate Series
Right-click on a series task to duplicate it.
Delete Series
Right-click on a series task to delete it.
Add Group
Right-click on a group task to add an additional group.
Add Smart Prep Group
Right-click on a Smart Prep group task to add an additional group.
Delete Group
Right-click on a group task to delete it.
Split and Link
Splits any
One or More
table position prescription within a single physical scan group and sepa‐
rates them into individual physical scan groups; then the start and end between groups are linked
and contiguous.
Split
Splits any
One or More
table position prescription within a single physical scan group and sepa‐
rates them into individual physical scan groups.
Link All
Links all scan groups in the series. Only the start of the first group and end of the last group can
be adjusted. The start and end between groups when adjusted will force the groups to be contig‐
uous. Use linked groups to adjust the location of a scan rotation boundary while keeping the
groups contiguous.
Unlink All
Unlinks all scan groups in the series, allowing them to be moved independently.
Rename
Rename the selected task.
Undo
Removes the last recorded right menu action.
NOTE: Unlinked groups are reconstructed as separate volumes for the primary and each
secondary recon. The primary recon of linked groups is reconstructed as a separate
volume for each table position. For secondary recons, all table positions are
reconstructed as a contiguous volume when
Add Recon
is set to
All
.
3.3 Exam Workflow Procedures
This is an overview of the steps necessary for a patient scan, from patient set up to image
management.
1.
Set up and position the patient.
2. Set up the patient’s information.
3.
Select a protocol.
4. Acquire a Scout scan.
5.
Acquire the scan data.
a. Set the Scan Parameters.
b.
Adjust the Graphic Rx.
c.
Set the Timing Parameters.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Chapter 11 Scan 249
To Next Page
Loading...
