GE Revolution CT - Set Grid; Set Series Binding; Set Tick Marks; Set Window Width; Window Level Presets

To view annotations in a larger font, click [Customize Large Font] and select the specific
annotation group to enlarge.
NOTE:
The system preset is set to
Full Annotation .
2.
Click [Save] to save the new preference, or [Save and Close] to additionally close the
System Preferences window.
3.2.2 Set Window Width / Window Level Presets
Use this procedure to set W/L preset values and define shortcut keys.
1.
In the
Window Width/Window Level Preset area, under Name , enter anatomical names for
each desired W/L preset.
2.
In the
WW and WL area, enter preset values for each anatomical name.
3. Click [Save] to save the new preference, or [Save and Close] to additionally close the
System Preferences window.
3.2.3 Set Series Binding
Use this procedure to set the default series binding.
1.
In the
Series Binding area, select On or Off .
○
On : To page through all series in an exam.
○
Off
: To page through only the current series in an exam.
2. Click [Save] to save the new preference, or [Save and Close] to additionally close the
System Preferences window.
3.2.4 Set Tick Marks
Use this procedure to set default tick marks to display.
1.
In the
Tick Mark area, select default tick marks to display:
○
Vertical & Horizontal : To show side and bottom tick marks.
○
Vertical
: To show side only tick marks.
○
Horizontal
: To show bottom only tick marks.
○
None
: To show no tick marks.
2. Click [Save] to save the new preference, or [Save and Close] to additionally close the
System Preferences window.
3.2.5 Set Grid
Use this procedure to customize the default grid display.
1.
In the
Grid area, set the following parameters:
a. Matrix Lines : Select On or Off .
b.
Line Style
: Select Dotted or Solid .
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Chapter 20 System Management 619