GE Revolution CT - Collect Data with SPR Snap

4.2 Collect Data with SPR Snap
Use this procedure to capture SPR information on the system.
NOTE:
Do not initiate an SPR Snap if the system is actively collecting data with X-ray on.
1.
From the image monitor, click .
2.
From the
Utilities menu, click Troubleshooting , then SPR Snap .
The sprsnap window will open to indicate that SPR Snap is in progress.
3. When SPR Snap is finished, the
sprsnap window will close. The SPR information will be
stored in the following system directory: usr/g/service/log, and can be retrieved be
your service representative. Note the directory location for future use.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Chapter 20 System Management 633