GE Revolution CT - Delete an Auto Voice Message

Use this procedure to record up to 17 additional voice messages (for each language) on your
system.
1.
From the image monitor, click .
2.
Click
Protocol Management , then Auto Voice Management
The Auto Voice Management window opens.
3. To record a message, select
Add Message from the drop-down menu.
○
The new message will be created with the Auto Voice message list for the selected
language.
○
Every new message must have a
Name and Description entered.
○
The
Name and Description should be easily identifiable (example - Mary S. Inspiration);
this helps identify whose voice is being used and the content of the message.
4. Select Pre .
5. Click [Record] and begin the pre-message.
○
Click and hold [Record] until you are ready to begin your message. Normally, you are
recording a pre-message first (example - “Take in a breath and hold it.”). When you
release the mouse button, the recording starts.
○
Begin your message right away.
○
Speak clearly into the microphone located on the scan control interface.
6. Click [Stop] as soon as you finish speaking.
○
If you make a mistake, simply click [Stop] and repeat these steps.
○
Try to start and stop the recording as quickly as possible to avoid adding time to the
beginning or end of a message.
7. Select Post .
8. Click [Record] and begin the post-message.
9. Click [Save].
NOTE: An Auto Voice message can only be saved if both a pre‐message and post‐
message are recorded.
10. To hear a recorded message, select the pre-message or post-message and click [Play] in
the Auto Voice Message area.
3.4 Delete an Auto Voice message
You may need to remove old or unwanted messages from the system as employees change or
as different languages are required. Use this procedure to delete an Auto Voice message.
1.
From the image monitor, click .
2. Click
Protocol Management , then Auto Voice Management
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
586 3 Auto Voice Management