GE Revolution CT - Auto Voice; Auto Voice Workflow; Set the Auto Voice Language

7 Auto Voice
Auto Voice provides recorded breathing instructions for the patient. Consistent breathing
instructions assist with more precise timing during an exam. Auto Voice also provides a pre-
message in the SmartPrep feature. The system also comes equipped with microphones at the
console and gantry for communicating with the patient.
The system has three, pre-recorded messages in ten selectable languages that cannot be
deleted. You can also record up to 17 additional messages for each language.
The default language for Auto Voice is set in your protocol. Default language options include:
•
Chinese
•
English (Female)
•
English (Male)
•
French
•
German
•
Italian
•
Korean
•
Japanese
•
Spanish (European)
•
Spanish (Latin America)
7.1 Auto Voice workflow
Use the Auto Voice feature to provide automated breathing instructions to the patient.
1.
Set the Auto Voice language.
2.
Add an Auto Voice language, if necessary.
3. Record an Auto Voice message.
4. Change the Auto Voice preset delay.
5.
Delete an Auto Voice message, if necessary.
7.2 Set the Auto Voice language
Use this procedure to set the language for Auto Voice.
1.
From the
Scan Settings window, in the Patient Position area, click Auto Voice .
2.
Select the desired Auto Voice language from the drop-down menu.
This selection will apply to all Auto Voice selections for the exam.
NOTE: After any scan is taken in the current series, the language cannot be changed.
The language can be changed if a new series is started.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Chapter 11 Scan 301