GE Revolution CT - Report a Cursor

2.
Click the [Add Line ROI] icon.
NOTE:
You can click the [Add Line ROI] icon from the viewport hover bar, which displays
when you hover your cursor over a viewport.
3.
Click and drag either end point of the start and end locations to adjust the line segment size.
4. Click the arrow next to
Export . Select ROI Text page.
○
This is useful when more than three measurements are on a viewport.
○
You can screen save Text page ROI.
5.
Click the [Erase Graphics] icon to erase all display objects.
4.5 Report a cursor
Use this procedure to display cursor statistics and Right Anterior Superior (RAS) coordinates for
a single pixel.
1.
From the viewport control panel, click the arrow next to
Measure/Annotate .
2.
Click the [Report Cursor] icon .
NOTE: You can click the [Report Cursor] icon from the viewport hover menu, which
displays when you hover your cursor over a viewport.
3. Click [Report Cursor] again to turn it off.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Chapter 14 View Images 397