•
interval is the interval of scan plane lines to be displayed. 2 equals every other image, 3
equals every third image, and so on.
For example, if you wanted to display lines showing previously scanned locations for the third
series, images 1 through 20, with the lines appearing on every third image, you would type: xra
3 1–20:3 into the Accelerator Line, and then press <Enter>.
5.6 Command Line
The Command box lets you enter command-line instructions for various functions that apply to
all active viewports.
1.
To view a list of all available commands, type ? in the
Command
box and press <Enter>.
2.
To enter a command, type the command and press <Enter>.
○
The command is applied to all selected viewports. As next and prior images are
selected, the command applies to those images.
○
Image selection from the
Command
box does not function if the primary viewport
contains an MIROI plot. Use prior/next series selection buttons from the viewport
hover menu.
○
On the left monitor access the command line by maximizing the viewport.
The table below lists available commands with descriptions and their applicable applications.
Table 6: Accelerator commands
Command / Description
Scan monitor
(left), scout view‐
port
Scan monitor
(left) viewport
Image monitor
(right) patient
session viewport
ac
Applies custom annotation to the image displayed as defined by
Display Preferences
set‐
tings.
X X X
af
Restores full annotation to the image displayed.
X X X
an
Removes all annotation from the image displayed.
X X X
ang
Creates an angle type measurement cursor by explicitly describing the end points of the lines
that make up the cursor.
X X X
ap
Applies partial annotation to the image displayed as defined by
Display Preferences
dialog
box on Exam Rx screen.
X X X
arrow <on> or <off>
Displays or removes an arrow cursor from a text annotation box for user annotation.
X X X
dist
A measure distance line will appear on the screen.
X X X
eag
Removes all graphics from the selected image.
X X X
eg
Removes selected graphics from the selected image.
X X X
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
402 5 Additional Image Tools
To Next Page
Loading...
