GE Revolution CT - Change a Users Password; Prompt a User to Change Password

Illustration 9: Change Name Window
5. Click [Confirm Change].
2.11 Change a user's password
Use this procedures to change a user's password.
1.
Section 2.4, Open EA3.
2.
From the
Local Users tab, select a user.
3. Click [Change Password].
4. From the
Change Password window, enter a new Password .
○
A password can contain uppercase letters, numbers, and special characters.
○
A password should not contain the same characters as the username.
○
An error message displays if the password does not meet the minimum length criteria.
The minimum criteria is displayed in the
Minimum Password Length field located at the
top of the Local Users tab. Change the password to an acceptable length.
Illustration 10: Change Password Window
5. Click [Confirm Change].
2.12 Prompt a user to change password
Use this procedure if you are an administrator to prompt a user to change his password on next
login.
1.
From the
Local Users tab, select a local user.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
Chapter 19 Access Controls 603