GE Revolution CT - Graphic Object for Rotate Reformats

Illustration 15: Graphic object – oblique reformats
1 Handle to extend coverage in any plane 3 Handle to move the entire reformat plan
2 Handle to rotate the reformat angle 4 Numbers showing start and end of reformat
1 represents the starting point. “N” is the ending point
3.2.5 Graphic object for rotate reformats
The graphic object used for planning a rotate reformat allows you to move the entire plan in the
recon scan area, change where the rotation will take place and where the start and end of the
reformat will be.
Revolution CT User Manual
Direction 5480385-1EN, Revision 1
430 3 Direct Multi Planar Reformat (DMPR)