Tricefy
Vivid S70 / S60 – User Manual 10-67
BC092760-1EN 01
Configure P1 button as TricefyPatientShare
1. Press Utility/Config on the control panel.
2. Select the Connectivity category and Additional Outputs
subgroup.
The Additional output sheet is displayed.
3. In Button field select P1.
4. Select TricefyPatientShare in the Available output field and
press the Right arrow button to assign it to the Selected
Output field.
5. Create a patient and check the Contact info box to register
a phone number in the Patient info and exam screen (see
Figure 10-48).
NOTE: If the exam result is to be shared with more than one
recipient, enter several phonenumbers seperated by
semicolon.
6. Get back to scan and press P1 button. The exam data will
be stored.
7. When an exam is finished, the exam data will be sent to the
Tricefy website. If a phone number is registered, a message
will be sent to the chosen recipient. The message gives the
patient the opportunity to check the exam result using a cell
phone.
Figure 10-48. The Patient info and exam screen
To Next Page
Loading...
