Customize Configuration
12-52 Vivid S70 / S60 – User Manual
BC092760-1EN
01
NOTE: Only jobs that failed or are in hold can be resent.
2. Press Resend.
To send a job to a new destination:
This is typically used if the configuration of the server is
changed.
1. Select the job(s) to send in the DICOM job spooler window.
NOTE: Only jobs that failed or are in hold can be sent to a new
destination.
2. Press Send to....
A dialogue window is displayed.
3. Select the new destination from the Destination pull-down
menu.
4. Press Send.
To hold a job:
1. Select the job(s) to hold in the DICOM job spooler window.
NOTE: Only inactive jobs can be set on hold.
2. Press Hold.
3. To undo hold, press Resend.
DICOM images
To configure DICOM images:
1. Press Utility/Config on the Touch panel and log on as
administrator.
2. Select the Connectivity category and DICOM subgroup.
The DICOM sheet is displayed.
Figure 12-36. The DICOM sheet
To Next Page
Loading...
