Scan Assist Pro Creator
Vivid S70 / S60 – User Manual 12-83
BC092760-1EN 01
Multi step views
Multi step views show the step attributes for all the steps in a
Protocol. There are six Multi step views: General, Comment,
Scan, Measure, Custom and All.
Figure 12-66. Multi step view (All)
The information displayed in each multi step view is
configurable.
1. Select Customize/Views.
The Customize multi step views window is displayed.
Each tab represents a different Multi step view. Within a tab,
the checked boxes are the step attributes that are displayed
in that Multi step view.
2. For each Multi step view check the attributes to be
displayed.
3. Select Save.
1. List of all steps in the Protocol
2. Attributes for all steps in the Protocol
To Next Page
Loading...
