Software update
Vivid S70 / S60 – User Manual 15-11
BC092760-1EN 01
Figure 15-2. The Exit dialogue window
2. Press Install.
The system will reboot automatically and the installation
process will begin. Do not power off the system
during the
software installation. The system will reboot during
installation. Please allow the system to completely install the
software.
NOTE: A typical installation may take up to 20 minutes.
When installation is complete, reboot the system. Perform
TCP/IP Save Settings (see page 15-13) and reboot. After a
Note: the SW Download section (lower part of the window) may take a few
seconds to be displayed.
• More Info: displays a window with information about the software to
download.
• Decline: the software is not downloaded, no update will be performed.
Note: If you choose Decline, you will not be prompted to install this
software update again unless you contact GE Service.
• Install: starts software installation.
To Next Page
Loading...
