Maintenance
15-12 Vivid S70 / S60 – User Manual
BC092760-1EN
01
few minutes the New software verification window is
displayed (see Figure 15-3).
Figure 15-3. Software verification
3. Perform a check for all features listed. Press to get
information on how to check each feature.
NOTE: You can press to minimize the Software verification
window and move it out of the way when testing.
Select Passed or Failed for each feature. If all features are
“Passed” the signature field is enabled.
Figure 15-4. Signature field enabled
4. Enter your signature (minimum three characters) and press
OK.
If for any reason the user select “Failed” for one of the
features tested, the system will roll back to the original
software version. Please call your local service
immediately.
To Next Page
Loading...
