GS corpuls3 - Approved Accessories, Spare Parts and Consumables

Maintenance and tests User Manual corpuls
3
212 ENG - Version 2.1 – P/N 04130.2
Functional
test
Description Measures by the user Correct result
CPR
Feedback
Function
check of the
CPR feedback
 Select manual mode of the
defibrillator.
 Connect the corPatch
CPR sensor to the
corPatch CPR
intermediate cable leading
to the patient box.
 Move the CPR sensor up
and down.
 If the CPR rate or -curve
are not displayed in a
parameter- or curve field, it
is possible that the
configuration has not been
set.
Assign the display to a
parameter- or curve field.
 The compression rate (CPR
rate) is displayed in a
parameter field.
 The CPR curve is displayed in
a curve field.
 The speech- and text
messages "Push harder"
and "Good compressions"
are played
Memory card Check the
Compact-
Flash
®
card
 Check if the
CompactFlash
®
card is
inserted into the patient
box.
 Check in the operation
browser whether there is
sufficient memory space for
further missions.
 The CompactFlash
®
card is
inserted into the patient box.
 A free memory space of at
least. 25% is indicated.
Printer Function
check of the
printer
 Check if sufficient printer
paper is available.
 Check if the marking
indicating the end of the
paper roll (red stripe) is
visible
 Run a test printout.
 A strip of paper is issued.
 The marking indicating the end
of the paper roll is not yet
visible. It is recommended to
load a new roll of paper as
soon as it is visible
 A replacement roll is present.
 The appearance of the type is
completely legible and of good
quality.
Switch-off Not applicable
 Operate the On/Off key
 Confirm the switch-off with
the softkey [OK]
 "
Power OFF?
" appears in the
message line.
 Display shows the shut-down
logo.
 The corpuls
3
is switched off.
Table
9-2 Function check of the device