IconMaster Installation and Configuration Manual 47
Chapter 2: Installation
Figure 2-32. A/O 2 Jumpers
Bypass Relay Jumper (HD or Multiformat Operation)
For HD or multi-format operation, jumper J10 should be left in the default
position, connecting pins 1 to 2. When a system is configured for SD, jumper
J10 should connect pins 2 to 3. See Figure 2-33 on page 47 for relay bypass
jumper location and settings.
Figure 2-33. Relay Bypass Jumper J10
AES A/O 2 unbalanced AES A/O 2 balanced
J1 J4 J2 J3
J1 J4 J2 J3
Program
input
Emergency
input
Program
output
Default HD positiom
Jumper J10 Settings
12
To Next Page
Loading...