HP 262SA - Page 193

Block Data Transfer
Table
9-4. ENTER Key Block Transfer Summary (Continued)
TERMIN-
ATING
DATA
END
MODE
CURSOR START
AGENT
TRANSFERRED
CHAR
CURSOR END
Au-toTerm
Cursor in protec-
---
Bell sounds. No
BT
Cursor
doesn't
(J) = YES
ted field.
data transmitted.
CR
move.
(LF)
Cursor" not cur-
NDT
All ASCII chars. If BT
Immediately
rently in a protec-
no data to be sent,
CR following the
ted field: An NDT
((end char" trans-
(LF)
terminator.
entered at current
mitted.
cursor position.
Then, cursor
moved to first pre-
vious BT or NDT.
If none, then cur-
sor homed.
EOF
Same as above
CR
First column
(LF)
following
end of
field.
If already an NDT
---
No data transmit-
BT
Cursor doesn't
at current cursor
ted, only uend
CR
move.
position. char".
(LF)
BLOCK PAGE
Home
up position BT All ASCII chars BT Immediately
NON-FORMAT (left margin ig-
NDT and the following following the
nored).
EOW Ec sequences: terminator.
AutoTerm
(J) = NO
• Video enhance-
Inh DC2
ment
(H) = YES
• Alt char set
• Field definition
Each line followed
by CR LF (regard-
less of whether
Auto Linefeed
mode is enabled or
disabled).
Last line
followed
by Uend
char" after the
usual CR LF.
If no data to be
sent, only nend
char" is transmi t-
ted.
9-15