EasyManua.ls Logo

HP 420

HP 420
363 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Command Line Reference
SNMP Commands
hpdot11StationRequestFail - A client station has failed associa-
tion, re-association, or authentication.
dot1xAuthFail - A 802.1X client station has failed RADIUS authen-
tication.
dot1xAuthNotInitiated - A client station did not initiate 802.1X
authentication.
dot1xAuthSuccess - An 802.1X client station has been success-
fully authenticated by the RADIUS server.
dot1xMacAddrAuthFail - A client station has failed MAC address
authentication with the RADIUS server.
dot1xMacAddrAuthSuccess - A client station has successfully
authenticated its MAC address with the RADIUS server.
dot1xSuppAuthenticated - The access point has been successfully
authenticated with the RADIUS server.
httpEnableStatusSet - The access point’s web server has been
enabled or disabled.
httpsEnableStatusSet -The access point’s secure web server has
been enabled or disabled.
iappContextDataSent - A client station’s Context Data has been
sent to another access point with which the station has associ-
ated.
iappStationRoamedFrom - A client station has roamed from
another access point (identified by its IP address).
iappStationRoamedTo - A client station has roamed to another
access point (identified by its IP address).
localMacAddrAuthFail - A client station has failed authentication
with the local MAC address database on the access point.
localMacAddrAuthSuccess - A client station has successfully
authenticated its MAC address witht the local database on the
access point.
mgntVlanIdSet - The access point’s management VLAN ID has
been changed.
possibleRogueApDetected - An access point has been detected
during a neighbor detection scan.
resetButtonEnableStatusSet - The access point’s reset button has
been enabled or disabled.
snmpVersionFilterSet - The filter for SNMPv3 or SNMP v1/v2
management access has been changed.
sntpServerFail - The access point has failed to set the time from
the configured SNTP server.
ssidPrimarySet - The access points primary SSID has been
changed.
sysConfigFileVersionChanged - The access point’s software file
has been changed.
8-44

Table of Contents

Related product manuals