File Transfers
Upgrade Procedure for v2.1.x Software
CLI: Version 2.1.x Software Upgrade using TFTP/FTP
The v2.1.x software upgrade can only be performed using the CLI, either
through a direct console connection or Telnet, or using SNMP. The upgrading
of the boot code cannot be performed using the web interface.
Note the following points before starting the upgrade procedure:
■ Make sure the access point is running a v2.0.x software version.
■ Place all the v2.1.x upgrade files into the root directory of the TFTP/FTP
server.
■ Be sure there is a stable network connection to the access point. If the
power to the access point or the network connection is lost, the upgrade
may fail and the access point be unable to boot.
■ Where possible, use a 100 Mbps connection to the access point’s Ethernet
port.
To Upgrade the Access Point to v2.1.x Software:
1. Download the temporary software file, hp420-tempimg.bin.
HP420#copy tftp file
1. Application image
2. Config file
3. Boot block image
Select the type of download<1,2,3>: [1]:1
TFTP Source file name:hp420-tempimg.bin
TFTP Server IP:192.168.1.10
Removing old runtime! Please wait a few minutes!
Creating file! Please wait a few minutes!
Firmware version of system is v2.0.38.0B037 and Updating
Run-Time code v02.00.40 NOW!
Updating Boot Line in NVRAM, please wait!
Warning! Updating firmware may cause configuration settings
to be incompatible.
(Suggestion:Using new default configuration settings lets
system be more efficient,but system will lose current
settings.)
Do you want to use NEW CONFIG SETTINGS? <y/n> [n]:n
HP420#
A-11
To Next Page
Loading...
Need help?
General
