HP 420

---------------------------------------------
---------------------------------------------
---------------------------------------------
---------------------------------------------
Command Line Reference
SNMP Commands
show snmpv3
This command displays the SNMP v3 users, trap targets, filter assignments
and settings.
Command Mode
Exec
Example
HP420#show snmpv3
EngineId :00:00:00:0b:00:00:00:30:f1:81:83:12
EngineBoots:4
SNMP Users
=============================================
UserName :chris
GroupName :RWPriv
AuthType :MD5
Passphrase:****************
PrivType :DES
Passphrase:****************
=============================================
SNMP Filters
=============================================
Filter: trapfilter1
Type: exclude
Subtree: iso.3.6.1.4.1.11.2.14.11.6.4.1.1.7.4.2.20
Mask: None
=============================================
SNMP Filter Assignment
=============================================
HostID FilterID
mytraps trapfilter1
=============================================
SNMP Targets
=============================================
Host ID : mytraps
User : chris
IP Address : 192.168.1.10
UDP Port : 162
=============================================
HP420#HP420#
8-52