HP 420

Command Line Reference
Wireless Interface Commands
shutdown
This command disables the radio interface. Use the no form to enable the
interface.
Syntax
shutdown
no shutdown
Default Setting
v2.0.37 software or earlier: Interface enabled
v2.0.38 software or later: Interface disabled
Command Mode
Interface Configuration (Wireless)
Example
HP420(if-wireless g)#shutdown
HP420(if-wireless g)#
enable
This command enables an SSID interface. Use the no form to disable the
interface.
Syntax
enable
no enable
Default Setting
Enabled
Command Mode
SSID Wireless Interface Configuration
Example
HP420(if-wireless-g-ssid-1)#enable
HP420(if-wireless-g-ssid-1)#
8-110