Wireless Interface Configuration
Managing Multiple SSID Interfaces
CLI: Modifying SSID Interface Settings
CLI Commands Used in This Section
Command Syntax CLI Reference Page
interface wireless g page 8-94
[no] ssid <index ssid- index | name ssid-name> page 8-96
ssid-name <string> page 8-96
[no] description <string> page 8-97
[no] enable page 8-110
vlan-id <vlan-id> <tagged | untagged> page 8-132
[no] closed-system page 8-98
show ssid <index | name> page 8-112
The following example shows how to modify SSID interface settings.
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless g)#ssid index 2
HP420(if-wireless-g-ssid-2)#no enable
HP420(if-wireless-g-ssid-2)#ssid-name open-access
HP420(if-wireless-g-ssid-2)#description unsecure access
HP420(if-wireless-g-ssid-2)#vlan-id 9 tagged
HP420(if-wireless-g-ssid-2)#closed-system
HP420(if-wireless-g-ssid-2)#
To display SSID interface settings, use the show ssid command, as shown in
the following example.
HP420#show ssid index 2
Wireless Interface Information
=========================================================================
----------------Identification-------------------------------------------
SSID : HP420
Primary : Yes
Tagging : Yes
Status : Enabled
VLAN ID : 2 (T)
6-27
To Next Page
Loading...
