Command Line Reference
Wireless Interface Commands
show ssid
This command displays the status for an SSID interface.
Syntax
show ssid <index ssid-index | name ssid-name>
• index - Specifies the index number of the SSID interface.
(Range: 1-8)
• name - Specifies the SSID of the interface.
(1 - 32 alphanumeric characters)
Command Mode
Exec
Example
HP420#show ssid index 1
Wireless Interface Information
=========================================================================
----------------Identification-------------------------------------------
Description : Guest Access
SSID : hp420
Primary : Yes
Tagging : Yes
Status : Enabled
VLAN ID : 2 (T)
----------------Security-------------------------------------------------
Closed System : ENABLED
802.11 Authentication : OPEN
WPA clients : DISABLED
802.1x : DISABLED
PMKSA Lifetime : 720 min
Encryption : DISABLED
Pre-Authentication : Disabled
Pre-Authentication : Disabled
8-112
To Next Page
Loading...
