HP 420

Command Line Reference
SNMP Commands
snmp-server location
This command sets the system location string. Use the no form to remove the
location string.
Syntax
snmp-server location <text>
no snmp-server location
text - String that describes the system location.
(Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Example
HP420(config)#snmp-server location WC-19
HP420(config)#
Related Commands
snmp-server contact (page 8-41)
snmpv3 engine-id
This command is used for SNMP v3. It is used to uniquely identify the access
point among all access points in the network. Use the no form to restore the
default engine ID.
Syntax
snmpv3 engine-id <engine-id>
no snmpv3 engine-id
engine-id - The engine ID in hexadecimal (5 -32 characters).
Default Setting
A unique engine ID is automatically generated by the access point.
Command Mode
Global Configuration
8-46