HP 420

Command Line Reference
802.1X Authentication
Example
HP420(if-wireless-g-ssid-1)#802.1x session-key-refresh-rate
5
HP420(if-wireless-g-ssid-1)#
802.1x session-timeout
This command sets the time period after which a connected client must be re-
authenticated.
Syntax
802.1x session-timeout <seconds>
seconds - The number of seconds. (Range: 0-65535)
Default
0 (Disabled)
Command Mode
SSID Wireless Interface Configuration
Example
HP420(if-wireless-g-ssid-1)#802.1x session-timeout 300
HP420(if-wireless-g-ssid-1)#
802.1x supplicant user
This command sets the user name and password used for authentication of
the access point when operating as a 802.1X supplicant. Use the no form to
clear the supplicant user name and password.
Syntax
802.1x supplicant user <username> <password>
no 802.1x supplicant user
• username - The access point name used for authentication to the
network. (Range: 1-32 alphanumeric characters)
• password - The MD5 password used for access point authentication.
(Range: 1-32 alphanumeric characters)
8-74