HP 420 User Manual

Command Line Reference
Wireless Interface Commands
ssid
This command enters SSID interface configuration mode for configuring
parameters for an SSID interface. Use the no f orm to remove a n SSID inte rface.
Syntax
[no] ssid <index ssid-index | name ssid-name>
• index - Specifies the index number of the SSID interface.
(Range: 1-8)
• name - Specifies the SSID of the interface.
(1 - 32 alphanumeric characters)
Default Setting
None
Command Mode
Interface Configuration (Wireless)
Command Usage
• When entering an SSID interface configuration mode using the index
number, the number is displayed in the CLI prompt. When using the
SSID name, the name is displayed in the CLI prompt.
• The primary SSID interface can only be deleted when it is the only
remaining interface defined.
Example
HP420(config)#interface wireless g
HP420(if-wireless-g)#ssid index 1
HP420(if-wireless-g-ssid-1)#
ssid-name
This command modifies the SSID for the interface.
Syntax
ssid-name <string>
string - The name of a basic service set supported by the access point.
(Range: 1 - 32 characters)
8-96

HP 420 Specifications

General

Model	HP 420
Category	Wireless Access Point
Data Link Protocol	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Security Features	WPA, WPA2
Power Source	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C