Using the Command Line Interface (CLI)
Using the CLI
Wireless Context . Includes wireless-specific commands that apply
globally to the wireless interface. The prompt for this mode includes the
identity of the wireless interface:
HP420(config)#interface wireless g Command executed at configuration
level to enter wireless context.
HP420(if-wireless-g)# Resulting prompt showing wireless
context.
HP420(if-wireless-g)#? Lists commands you can use in the
wireless context.
In the wireless
context, the
commands in
the "?" listing
show the
commands that
affect only the
wireless
interface.
HP420(if-wireless-g)#?
antenna-mode Set antenna mode
ap-detection Configure rogue ap parameters
beacon-interval Set beacon interval
channel Set channel
description Set description
dtim-period Set DTIM
end End config mode
exit Exit to previous mode
fragmentation-length Set fragment length
help Description of the help system
max-association Maximum association munber
multicast-data-rate Set multicast data rate
no Negate
preamble Preamble length
radio-mode Set 802.11g mode
rts-threshold Rts threshold
show Show wireless interface
shutdown Stop radio
slot-time Fix the slot time
speed Speed
ssid Create and go to a particular SSID
transmit-limits Set detachable antenna gain attenuation
transmit-power Transmit power
HP420(if-wireless-g)#
Figure 3-8. Context-Specific Commands Affecting Wireless Context
3-14
To Next Page
Loading...
