Wireless Interface Configuration
Modifying Antenna Settings
Figure 6-3. Antenna Mode and Port/Radio Settings Window
CLI: Setting the Antenna Mode and Transmit Power
Control Limits
CLI Commands Used in This Section
Command Syntax CLI Reference Page
interface wireless g page 8-94
antenna-mode <diversity | single> page 8-99
transmit-limits <low> <middle> <high> page 8-107
show interface wireless g page 8-111
Using the CLI to Set the Antenna Mode. The following example shows
how to set the antenna mode for the access point when using a non-diversity
antenna.
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless-g)#antenna-mode single
HP420(if-wireless-g)#
6-19
To Next Page
Loading...
