HP 420 User Manual

Getting Started
Introduction
Introduction
This Management and Configuration Guide is intended to support the
following access points:
■ HP ProCurve Wireless Access Point 420 na
■ HP ProCurve Wireless Access Point 420 ww
This guide describes how to use the command line interface (CLI) and web
browser interface to configure, manage, and monitor access point operation.
A troubleshooting chapter is also included.
For information on other product documentation for this access point, refer
to “Related Publications” on page 1-4.
The Product Documentation CD-ROM shipped with the access point includes
a copy of this guide. You can also download a copy from the HP ProCurve
website, http://www.hp.com/go/hpprocurve
. (See “Getting Documentation From
the Web” on page 1-5.)
Conventions
This guide uses the following conventions for command syntax and displayed
information.
Command Syntax Statements
Syntax: radius-server address [secondary] <host_ip_address | host_name>
■ Vertical bars ( | ) separate alternative, mutually exclusive elements.
■ Square brackets ( [ ] ) indicate optional elements.
■ Braces ( < > ) enclose required elements.
■ Braces within square brackets ( [ < > ] ) indicate a required element
within an optional choice.
■ Boldface indicates use of a CLI command, part of a CLI command
syntax, or other displayed element in general text. For example:
“Use the copy tftp command to download the key from a TFTP server.”
1-2

HP 420 Specifications

General

Model	HP 420
Category	Wireless Access Point
Data Link Protocol	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Security Features	WPA, WPA2
Power Source	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C