Command Usage
This command is used in conjunction with the filter ethernet-type protocol
command to determine which Ethernet protocol types are to be filtered.
Example
HP420(config)#filter ethernet-type enable
HP420(config)#
Related Commands
filter ethernet-type protocol (page 8-84)
filter ethernet-type protocol
This command sets a filter for a specific Ethernet type. Use the no form to
disable filtering for a specific Ethernet type.
Syntax
filter ethernet-type protocol <protocol>
no filter ethernet-type protocol <protocol>
protocol - An Ethernet protocol type.
– Aironet-DDP
– Appletalk-ARP
– ARP
– Banyan
– Berkeley-Trailer-Neg
– CDP
– DEC-LAT
– DEC-MOP
– DEC-MOP-Dump-Load
– DEC-XNS
– EAPOL
– Enet-Config-Test
– Ethertalk
– IP
– LAN-Test
– NetBEUI
– Novell-IPX(new)
– Novell-IPX(old)
– RARP
– Telxon-TXP
– X25-Level-3
To Next Page
Loading...
