HP 420 User Manual

Command Line Reference
RADIUS Accounting
RADIUS Accounting
The access point provides configuration for RADIUS Accounting servers that
can receive user-session accounting information from the access point.
RADIUS Accounting can be used to provide valuable information on user
activity in the network.
Command Function Mode Page
radius-accounting- Enables RADIUS Accounting GC 8-67
server enable
radius-accounting- Specifies the RADIUS Accounting server GC 8-68
server address
radius-accounting- Sets the RADIUS Accounting server network port GC 8-68
server port-accounting
radius-accounting- Sets the RADIUS Accounting encryption key GC 8-69
server key
radius-accounting- Sets the number of retries GC 8-69
server retransmit
radius-accounting- Sets the interval between sending authentication GC 8-70
server timeout requests
radius-accounting- Sets the interval between transmitting accounting GC 8-71
server timeout-interim updates to the RADIUS server
show radius Shows the current RADIUS settings Exec 8-65
radius-accounting-server enable
This command enables RADIUS Accounting globally on the access point. Use
the no form to disable RADIUS Accounting.
Syntax
radius-accounting-server enable
no radius-accounting-server
Default Setting
Disabled
8-67

HP 420 Specifications

General

Model	HP 420
Category	Wireless Access Point
Data Link Protocol	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Security Features	WPA, WPA2
Power Source	Power over Ethernet (PoE)
Operating Temperature	0°C to 40°C